top of page
Number of cameras2 stationary cameras
Camera type5 MPix machine vision industrial cameras, RAW
Mounting typeFloor-mount. T-shaped pillar
Cabinet typeLight-series (attached to the pillar)
ApplicabilityLift or Pit
Distance from cameras to the center of front turn tables1500-2500mm, recommended distance 2200mm
Main advantages
  • 2-camera configuration is sufficient to organize a wheel alignment post on any pit;
  • Set of 5Mpix cameras allows a better use of the aligner on the lift*;
  • Does not need calibration and allows you to start working right after installation**.

* For lifts, the measurement height can be at approximately 900mm above the floor;
** Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement. 
 

INSTALLATION AND CALIBRATION

MountingRequired (floor)
Calibration after mountingNot required*

* Only when taking measurements in the plane of a vehicle. To take measurements relative to the horizontal plane it is necessary to perform horizon measurement. 

Installation and calibration must be performed by a certified specialist. 
This wheel aligner is supplied pre-calibrated and can be used right after installation.

Techno Vector 7 Aluminium 7202 T 5 A

    bottom of page